2006 Sterling ActerraACTERRA

DAIMLER TRUCKS NORTH AMERICA IS RECALLING CERTAIN MODEL YEAR 2005 THROUGH 2012 FREIGHTLINER M2, STERLING ACTERRA, 7500 & 8500, AND THOMAS BUILT HDX VEHICLES MANUFACTURED FROM JUNE 23, 2004, THROUGH MARCH 15, 2011, EQUIPPED WITH SPECIFIC MBE900 EPA04 AND EPA07 MODEL ENGINES. THE INTAKE AIR GRID HEATER MAY SHORT CIRCUIT AND FAIL DUE TO EXCESSIVE INTERNAL TEMPERATURES.

DAIMLER TRUCKS IS RECALLING 28,764 MY 2001 THROUGH 2008 FCCC B2 AND FS65 SCHOOL BUS CHASSIS, FCCC FB65 CONVENTIONAL BUSES, AND STERLING ACTERRA, FREIGHTLINER FLN, AND BUSINESS CLASS M2 HEAVY TRUCKS, BUILT FROM JANUARY 26, 2000, THROUGH MARCH 24, 2008, MANUFACTURED WITH ARVINMERITOR OR AXLE ALLIANCE COMPANY 6,000 THROUGH 8,000 POUND FRONT AXLES UTILIZING A FOUR PIECE SPINDLE-NUT SET. THESE AXLE ASSEMBLIES MAY HAVE BEEN PRODUCED WITH A THIN SPINDLE NUT WHICH MAY LEAD TO INCORRECT END PLAY, CONE SPIN, EXCESSIVE HEAT, DEGRADATION OF LUBRICATION, WEAR OF THE SPINDLE NUT AND BEARING JOURNAL, OIL CONTAMINATION WITH METAL SHAVINGS, AND PREMATURE BEARING FAILURE.

ON CERTAIN TRUCKS EQUIPPED WITH VISTEON WINDSHIELD WIPERS, THE MOTOR MAY HAVE BEEN PRODUCED WITHOUT GREASE APPLIED TO THE OUTPUT SHAFT GEAR.

DAIMLER TRUCKS NORTH AMERICA (DTNA) IS RECALLING 24,650 SCHOOL AND NON-SCHOOL BUSES, MOTOR HOME CHASSIS, AND TRUCKS MANUFACTURED FROM MARCH 9, 2004 THROUGH AUGUST 18, 2006, EQUIPPED WITH EPA04 CERTIFIED MBE900 ENGINES, MANUFACTURED BY DETROIT DIESEL BETWEEN MARCH 1, 2004, AND JULY 31, 2006. THE HIGH PRESSURE FUEL LINES AND TRANSFER TUBES MAY FATIGUE AND FRACTURE.

CERTAIN FREIGHTLINER SCHOOL BUS CHASSIS, HEAVY TRUCKS, AND THOMAS BUILT SCHOOL BUSES MANUFACTURED BETWEEN JULY 2002 AND JULY 3, 2007, EQUIPPED WITH BENDIX SR-7 SPRING BRAKE CONTROL VALVES. THE PARKER SCV BRASS 90 DEGREE SINGLE CHECK VALVES (SCV) WHICH ATTACH TO THE SUPPLY PORT OF A BENDIX SR-7 SPRING BRAKE MODULATING VALVE CAN BREAK APART. PIECES OF THE PARKER SCV CAN BECOME LODGED INSIDE THE SR-7 SPRING BRAKE MODULATING VALVE, POTENTIALLY CAUSING EITHER LEAKAGE OUT OF THE SR-7 VALVE OR PREVENTING AIR FROM PROPERLY EXHAUSTING FROM THE SR-7 VALVE. ALSO, DUE TO A MANUFACTURING DEFECT IN THE INTERNAL RUBBER CHECK VALVE INSIDE THE SR-7 SPRING BRAKE MODULATING VALVES, THE VALVES CAN BECOME DEFORMED AND NOT SEAT PROPERLY.

ON CERTAIN TRUCK-TRACTORS EQUIPPED WITH HOLLAND SIMPLEX SE OR SE II FIFTH WHEELS, THE LATCH LEVER PIVOT BOLT ASSEMBLY MAY HAVE BEEN OVER-TIGHTENED WHICH COULD DISTORT THE PIVOT BOLT SPACER SLEEVE. CORROSION OR CONTAMINATES IN THE PIVOT MAY CAUSE IT TO BIND AND PREVENT THE FIFTH WHEEL JAW FROM LATCHING SECURELY AROUND THE TRAILER KING PIN.