1999 Dodge DakotaDAKOTA

SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

SKF IS RECALLING 2,805 HUB UNITS, PART NO. BR930361, SOLD AS A SERVICE PART FOR 1997-2004 DODGE DAKOTA VEHICLES AND 1999-2003 DODGE DURANGO VEHICLES EQUIPPED WITH 2-WHEEL DRIVE & REAR AXLE ABS. DUE TO A SPECIFICATION ERROR, THE ROTOR PILOT FOR THE HUB UNIT MAY BE TOO LONG. THIS RESULTS IN THE WHEEL TO NOT BE SEATED FULLY AGAINST THE HUB FLANGE FACE DURING MOUNTING.

CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

CERTAIN AJ MOTORSPORT COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LISTED PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

CERTAIN REPLACEMENT K&N FUEL PERFORMANCE KITS, P/NOS. 57-1509, 57-1511, 57-1511-1, 57-1517, 57-1517-1, 57-1527, AND 57-1530. ALSO, A SMALL PERCENTAGE OF THESE KITS WERE SOLD UNDER THE MOPAR PERFORMANCE PARTS BRAND NAME (P/NOS. P5007069 AND P5007070). ALL KITS WERE MANUFACTURED FROM APRIL 20, 1999, THROUGH SEPTEMBER 23, 2004. THESE ASSEMBLIES WERE MANUFACTURED AS REPLACEMENT EQUIPMENT FOR CERTAIN DODGE PICKUP TRUCKS AND SUVS. A SMALL PIECE OF MATERIAL FROM THE TUBE WALL COULD BE SUCKED INTO THE ENGINE THROTTLE BODY, WHICH COULD CAUSE THE THROTTLE TO BECOME JAMMED IN THE OPEN POSITION.