2001 Dodge DakotaDAKOTA

SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

ON CERTAIN SPORT UTILITY VEHICLES AND PICKUP TRUCKS EQUIPPED WITH FOUR-WHEEL DRIVE (4X4), IF MOISTURE LEAKS INTO THE FRONT SUSPENSION UPPER BALL JOINT, EVACUATION OF THE LUBRICANT AND CORROSION OF THE JOINT MAY CAUSE THE JOINT TO WEAR OVER AN EXTENDED PERIOD OF TIME. THIS COULD CAUSE A CLUNKING NOISE IN THE FRONT SUSPENSION, WHICH MAY NOT ALWAYS BE HEARD BY THE VEHICLE OCCUPANTS.

DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

SKF IS RECALLING 2,805 HUB UNITS, PART NO. BR930361, SOLD AS A SERVICE PART FOR 1997-2004 DODGE DAKOTA VEHICLES AND 1999-2003 DODGE DURANGO VEHICLES EQUIPPED WITH 2-WHEEL DRIVE & REAR AXLE ABS. DUE TO A SPECIFICATION ERROR, THE ROTOR PILOT FOR THE HUB UNIT MAY BE TOO LONG. THIS RESULTS IN THE WHEEL TO NOT BE SEATED FULLY AGAINST THE HUB FLANGE FACE DURING MOUNTING.

CERTAIN AFTERMARKET AIRTEX ELECTRIC FUEL PUMPS INSTALLED FOR USE AS REPLACEMENT EQUIPMENT FOR CERTAIN 1997-2004 JEEP WRANGLER; 1997-2001 JEEP CHEROKEE; 1997-2004 JEEP GRAND CHEROKEE; AND 2000-2003 DODGE DAKOTA VEHICLES. THE PLASTIC ELECTRICAL GROMMET CONNECTORS AT THE TOP OF THE FUEL PUMP MODULE ARE NOT COMPATIBLE WITH AUTOMOTIVE FUELS AND MAY DEGRADE CAUSING A POTENTIAL LEAK PATH FOR FUEL.

ON CERTAIN VAN AND PICKUP TRUCKS EQUIPPED WITH AUTOMATIC TRANSMISSIONS, THE IGNITION/PARK SHIFT INTERLOCK SYSTEM MAY BECOME INOPERATIVE. THIS CAN ALLOW THE SHIFTER TO BE MOVED OUT OF THE "PARK" POSITION WITH THE IGNITION KEY REMOVED (OR IN THE "LOCK" POSITION). THIS CAN ALSO ALLOW THE IGNITION KEY TO BE REMOVED WHEN THE SHIFTER HAS NOT BEEN PLACED IN THE "PARK" POSITION.